Price: 25.92

Net weight: 331gProduct package size: 12.5*10*13cm

Equipment parameter

Power supply: 2 1.5V dry batteries

Quiescent current: 5uA

Working water pressure: 1-5kg

Working temperature: 0-60℃

Working flow: 456-1432L/h

Output control mode: pulse output

Rated power consumption: <1W

Waterproof grade: IP65

Generally, the service life of the battery is about 12 months. In order to prevent the battery from being used up and the water cannot be shut off, the battery needs to be replaced in time. Open the transparent cover, replace the battery and complete the program setting, please cover the waterproof transparent cover in time.

Controller installation

1. Pull out the battery drawer and put in 2 1.5V dry batteries

2. Insert the connector

3. Tighten with the movable cover

4. Tighten the nipple connector

5. Insert the quick connector

6. Set the watering program

Please keep the controller installed vertically

Please keep the controller installed vertically

Please keep the controller installed vertically

Please keep the controller installed vertically

Controller InstructionsOn the left is the cycle frequency of the control time. The optional cycle ranges from the minimum cycle of 1 hour to the maximum cycle of 1 week. There are 11 optional cycle frequencies in total, and there is also a frequency reset file.

Indicator light: When the water outlet is set and when the water outlet is turned off, there will be double flashing prompts. It usually flashes once every 5 seconds, indicating that the battery is still charged. Replace the battery when it does not flash or is always on.

On the right is the watering time and switch, the optional time ranges from the minimum watering time of 1 minute to the maximum watering time of 120 minutes, a total of 10 optional watering times. "On" and "Off" are manual control switches.

When the frequency gear is in the reset gear and the time gear is in any minute gear position, it will enter the test mode after 15 seconds (perform a switch operation every 3 seconds).

1. Irrigation program setting: (any operation will be executed within 5 seconds)

Step 1: Select the watering frequency by dialing the dial on the left. Step 2: Select the watering time on the right. Example: Set watering for 5 minutes every hour. (1). First select the watering time by dialing the code on the right: 5 minutes; (2). Then select the watering frequency by dialing the code on the left: 1 hour. Start watering for 5 minutes, stop watering after 5 minutes, and water again for 5 minutes after every hour.

2. Reselect the frequency:

When I want to change the frequency, I first select the time, and then select the frequency gear. Every time I change the frequency gear, the internal timing will be reset.

3. Temporary irrigation:

Turn the frequency dial on the left to "reset", turn the right dial to "on" to water, and turn it to "off" to turn it off.

4. Program protection:

The time interval must be greater than the watering time, otherwise the machine will not start watering when the time comes, and it will stop this function during watering. For example: if the frequency is selected as 1 hour, and the watering time is 90 minutes, no water will be produced if the setting is unsuccessful. If you choose 1 hour to 1 minute at the beginning, when watering, if the watering time is set to 90 minutes, the watering will stop immediately and the setting will fail.