Price: 20.78
The water level and liquid level switch sensor controller is carefully developed for the actual needs of family factories and mines. It is based on the detection of the water level of the pool (water tower) to control the high current relay to achieve control. It has the characteristics of small size, simple wiring, low power consumption, large switch capacity, strong anti-interference, and high functional stability. It can stably realize that when the pool (water tower) is short of water, the water pump is automatically started for pumping, and the pump is automatically stopped when it is full.
Module Parameters:
Power supply voltage: DC 12V (other home AC 220V and 380V versions)
Type: Switching level controller (12V power supply voltage, the load can be non-12V or AC load)
Control motor power: within 1000W is recommended.
Specification size: 60*50*22mm
Note:
The probe is a weak current below 12V. Be sure to connect the upper, middle and lower three wires, not just two wires. You can buy a special probe for the probe, or you can use ordinary wires to strip the wire end 3-5 cm to make it a bare wire for direct sensing.
Reviews
There are no reviews yet.