Price: 15.90 - 19.39
Name: Micro Diaphragm Pump
60W 80W 100W
12v-60W 80w
12V-100W
24V-100W
60W 80W 100W, power (maximum output):
Maximum output water pressure: 0.8Mpa
Flow rate (maximum): 5L/min
100 watt pump, power (maximum output):
Voltage: DC12V-8A
Voltage: DC24V-5A
Working pressure: 7-11kg
Flow rate: 8L/min
Note: The correct power supply must be matched
Filters must be used at the entrance
Connection thread: 1/2 "18mm" connection hose 3/8 ""
Function:
1. Pressure switch type: when the outlet is completely blocked,
When the set maximum pressure value is reached, the 60w 80w power supply will be automatically cut off.
The motor stops and restarts before running.
100W, cannot be turned off automatically, need to cut off the power.
The hose hole should not be too small, otherwise it will damage the pressure switch in the pump.
2. The mounting feet are made of rubber instead of hard plastic, which can provide good vibration isolation.
3. Connect the water inlet and outlet to the silicone PE or pu pipe.
Frequently Asked Questions
Is the pump ringing? If it does not absorb water, will it burn at idle speed?
The pump has a certain noise when working, about 70 decibels. The water inlet pipe adopts hose, and the pump is fixedly installed to reduce noise. Not idling for a long time will not damage the pump, but it is not a good idea to let the pump dry for too long.
Is the pump water?
Each pump has been tested before leaving the factory, so there will be clean water in the water, and there is a red waterproof cap on the thread to prevent the pump from being too dry and not absorbing water for a long time.
What motor is used in the pump?
Full copper wire double-roller DC motor (power cord is not divided into positive and negative poles), continuous service life exceeds 1100 hours
Note: The size is measured manually, please allow slight measurement error.
Reviews
There are no reviews yet.